Hettich Door Bend Adjustment Rod Fittings
For straightening distorted furniture doors
It can also be used as a precautionary measure to prevent doors from warping
For door / front panel thicknesses from 16 mm
Maximum door / front panel height 2600 mm
Installing the fitting is simple and straightforward: a pair of threaded rods, one with a right-hand thread and one with a left-hand thread, are fed into a clamping sleeve
The threaded rods are each additionally supported in a housing that slots into a 35 mm drilling where it is screwed into place
Turning the clamping sleeve produces a tensile or compressive force that corrects door warping or bowing
The housing, clamping sleeve, and threaded rods are covered to prevent damage to the wardrobe and laundry
The adjustment fitting can also be used horizontally
It is recommended that 2 vertical adjustment fittings be installed near the outer edge. On large, wide doors, 2 horizontal fittings can be used instead or in addition
2 adjustment fitting sets are required per door
